Mcz Philo User Manual download pdf (Page 44)

PELLET STOVES Chapter 9

USE AND MAINTENANCE MANUAL

page 44

Faults/Causes/Solutions Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited

FAULT POSSIBLE CAUSES REMEDIES

The smoke extraction

motor does not work

 No electricity supply to the stove.

 The motor is broken.

 The board is faulty.

 The control panel is broken.

 Check the supply voltage and the

protection fuse.

 Check the motor and capacitor and

replace if necessary.

 Replace the circuit board.

 Replace the control panel.

The air convection fan

never stops.

 Temperature control heat sensor

defective or faulty.

 Fan faulty

 Check the operation of the sensor

and replace it if necessary.

 Check the operation of the motor

and replace it if necessary.

The remote control

does not work

 Remote control batteries flat.

 Remote control faulty

 Replace batteries

 Replace the remote control.

In automatic mode,

the stove always runs

at full power.

 Room thermostat in maximum position.

 Temperature detector sensor faulty.

 Control panel faulty or broken.

 Reset the thermostat temperature.

 Check the sensor and replace it if

necessary.

 Check the panel and replace it if

necessary.

The stove will not start

 Power failure.

 Pellet sensor has seized up.

 Fuse blown.

 Smoke outlet or duct clogged.

 Some alarms active

 Make sure the appliance is plugged in

and that the main switch is set to “I”.

 Release it by resetting the rear

thermostat. If it happens again replace

the thermostat.

 Replace the fuse.

 Clean the smoke outlet and/ or the

smoke duct.

CAUTION!

The operations marked in bold must only be

performed by specialised MCZ personnel.

The manufacturer will not be held liable and the

guarantee will not be valid if this condition is not

abided by.

1 2 ... 39 40 41 42 43 44 45 46

Comments to this Manuals

No comments