Mcz Philo User Manual Page 34

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 33
PELLET STOVES Chapter 6
USE AND MAINTENANCE MANUAL
page 34
Emergency panel Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
D
E
ON
OFF
6.1.1. Start-up/ shutdown via the emergency panel
If the remote control is faulty or the batteries are flat you can operate
the stove temporarily using the emergency panel on the rear of the
stove.
In this configuration, the stove can be operated manually and you can
choose between 3 power levels.
STARTING UP THE STOVE WITHOUT THE REMOTE
CONTROL
To start up the stove move selector “D” to the ON. When the
stove starts up the RED LED will switch off and the GREEN LED
will begin to flash until the start-up process is complete. The
GREEN LED stays on permanently while the stove is running.
SELECTING THE POWER LEVEL WITHOUT THE REMOTE
CONTROL
You can choose between three heating power levels:
MIN-MED-MAX (selector “E”)
MINIMUM power is the 1
st
power level;
MEDIUM power is the 3
rd
power level;
MAXIMUM power is the 5
th
power level;
SHUTTING DOWN THE STOVE WITHOUT THE REMOTE
CONTROL
To shut down the stove move selector “D” to the OFF
Once the remote control is working again remember
to put selector "D" back to the "REMOTE" position
otherwise the stove will ignore input from the
remote control.
6.1.2. Carica coclea (Load pellet)
This function, which can only be enabled when the stove is switched
off, is used to load pellets into the filling system (auger), and it can be
used every time the same is emptied because the pellets in the tank
have run out (see alarm A02). It is useful to avoid failed start-ups
(alarm A01) due in fact to an empty tank.
To enable the CARICA COCLEA (LOAD PELLET) function, when the
stove is switched off, set the selector “D” on the emergency panel to
OFF and press the TEST key on the same panel three times. Wait a
few seconds and the word COCLEA (AUGER) will flash on the screen.
When the pellets begin to drop into the brazier, press the TEST key
again to disable the CARICA COCLEA (LOAD PELLET) function and then
start up the stove.
D
E
ON
OFF
C A R
TEST
C O C
TEST
Page view 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 45 46

Comments to this Manuals

No comments