Mcz Cap NATURAL User Manual download pdf (Page 66)

15-CLEANING

ATTENTION!

All the cleaning operations of all parts must be performed with the product completely cold and the plug

disconnected.

Disconnect the product from the 230V power supply before performing any maintenance operation.

The product requires little maintenance if used with certied good quality pellets.

DAILY OR WEEKLY CLEANING PERFORMED BY THE USER

Before each lighting

Clean and empty any ash or deposits from ash drawer “C” that might obstruct the air ow holes, paying attention to any hot ashes.

If the pellets in the hopper run out, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before each

start-up.

You may only use a vacuum cleaner to remove ash when it is completely cold. In this case, use a suitable vacuum cleaner

to remove small sized particles. The quality of the pellets used and user experience will determine the cleaning frequency required.

However, it is recommended not to exceed 2 or 3 days.

REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE IGNITION AND OPTIMAL

OPERATION OF YOUR PELLET PRODUCT.

For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the

bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the

component.

CLEANING THE GLASS

It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.

ATTENTION!

Do not use abrasive products and do not spray the glass cleaning product on the painted parts and on the door

gaskets (ceramic bre cord).

EXAMPLE OF A CLEAN BRAZIER EXAMPLE OF A DIRTY BRAZIER

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

No comments

Mcz Cap NATURAL User Manual Page 66