Mcz AirSystem 70 DX User Manual download pdf (Page 24)

Chapter 4

INSTALLATION AND USE MANUAL

page 24

• Before putting the hermetic bottom C back in place, make the

electrical connections as shown in the following paragraph.

• Once the electrical connections are complete, put the hermetic

bottom C back in place and secure it with the self-tapping screws

(figure 14)

• Re-insert the fire beds, the drawer and the ash grille

Make sure that the removable bottom C is

hermetically sealed and that the gaskets mounted on

the bottom are in good shape.

4.9. CONNECTION OF CONTROL UNITS AND

PROBES

All wiring must be carried out with the electrical

sockets disconnected. Make sure that the electrical

sockets are grounded.

4.9.1. Control unit FC715 and probe installation

Arrange in advance for the connections of the control unit FC715 as

shown in

diagram 1

of page 29 if you are installing a kit of 480-620

or as in

diagram 2

on page 30 if you are installing a kit of

180m

/h.

PROBE INSTALLATION:

• Screw in without tightening completely the screw that holds

the probe G to the probe support E, placing in between the bush

(figure 16).

• Screw in the entire probe support E+F+G in the hole D (size 10

wrench)

• Insert probe H all the way into the hole of the screw that holds

probe G and gently tighten the screw G (size 7 wrench).

• The probe will be inserted in the upright of the fireplace stove C.

Once the connection is complete and the plug placed in the socket of

the home, check that the red LED on the control unit lights up.

All wiring must be carried out with the electrical

sockets disconnected. Make sure that the electrical

sockets are grounded.

4.9.2. Positioning of control unit and FC715

The control unit must be placed on the floor, behind or alongside the

fireplace stove, in a zone that is accessible for maintenance and above

all far from the bottom of the structure as shown in

figure 17.

Make sure that the control unit does not come into hot metallic parts of

the fireplace stove, as it can be damaged by heat.

The equipment must be powered at 220V at 50Hz.

Correct connection to the earth system is vital.

Make sure that the cables do not come into contact with the

metal parts of the structure, as they get extremely hot.

Figure 14 – Installation of bracket with terminal

board

Piedino posteriore

Sezione del piano fuoco

Griglia cenere

Cassetto

cenere

Figure 16 – Probe installation

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 36 37

Comments to this Manuals

No comments

Mcz AirSystem 70 DX User Manual Page 24

Comments to this Manuals

Related products and manuals for Kiln Mcz AirSystem 70 DX